Home Page Product
View
  Barrel, removable type
  High speed finishing & polishing
  No cuts or scratches
  Uniform finish and polish
  Barrel location controlled by Jog Button
  Recommendable for imitation jewellery & dental parts
  2 types of barrels are available, vertical or horizontal
   
  Variable Speed Controller(Inverter)
  P.U lined
  Frame with stainless steel
   

  The HZ Series Finishing Machines provide the most economical, high speed finishing available. The variable frequency speed control permits fine finishing and polishing at slower speeds and aggressive deburring and edge radiusing at higher speeds.

Four barrels are mounted at the periphery of a large turret. Each barrel is loaded with media, parts and water to approximately 50% to 90% capacity. During operation, rotation of the large turret creates a centrifugal force on the media and parts inside each barrel. This force compacts the load into a tight mass causing the media and parts to slide against each other, removing burrs and creating superior finishes. This action also reduces the cycle time needed to complete the finishing of the parts by up to a factor of 30 over conventional vibratory and barrel finishing.
  A closer look at the barrel will show that the barrel is circulated under high pressure, as shown in figure H-2. So the parts can be finished in a short period of time.

MODEL

Machine Size

Barrel Size

Main Motor

R.P.M

Total Capacity
(?)

Weight
(Kg)

Width

Length

Height
(HZ)

Width

Length

Height
(1SIDE)

HZ-4
960
770
1,000
130
130
150
1 HP
250
4
300
HZ-8
160
160
160
2 HP
250
8
350
HZ-12
230
230
170
2 HP
250
12
400

 
Top
 
Untitled Document
Copyright 2006 PRO DCM CO.,LTD @ All Rights reserved